
LP-2 · Pre-grinding & polishing
LP-2



Explore the original technical specifications, related methods and configuration options. Chinese source specifications are retained for accuracy.
YM-1单盘台式金相预磨机在金相试样制备过程中,试样的预磨,是抛光前必不可少的前道工序,先将试样预磨光后,可大大提高试样制备的功效,YM-1预磨机,是通过对多方预磨的需要,该机的磨盘直径大于国内同类产品,磨盘的转速也不同于国内产品,是试样预磨的合适设备。
| Parameter | Value / description |
|---|---|
| Grinding disc diameter | ¢200mm |
| Grinding disc speed | 700r/min |
| Motor power | 200W/低NoiseMotor |
| Supply voltage | 380V,50HZ |
| Dimensions | 460*340*330mm |
| Weight | 22kg |
Confirm the applicable method and standard.
Topic-based references do not certify this model or establish full conformity. Confirm the applicable edition, configuration and test conditions.
Scientific detail below is the Chinese source edition; reviewed full translations are pending.
Series-level guidance · Sample preparation · Confirm model capabilities, accessories and specifications.
Abrasives and polishing media remove surface material step by step, balancing flatness, edge retention and the removal rates of different phases. The final surface must pass microscopic inspection.
The schematic explains the basic mechanism; it is not a structural drawing of this model, an operating instruction or a measured result.
Progressive grinding and removal of the surface deformation layer
Schematic model, not device footage or experimental data.
Follow inputs, actions, outputs and quality gates.
Define the research question: Do scratches, smearing or pull-out come from preparation or from the material?; Does relief or edge rounding occur between soft and hard phases? Record sample identity, target result and required configuration in the test plan.
Assess previous cutting damage and mounting quality; record sample orientation and target area.
Check grinding disc flatness, fixture parallelism, rotation speed and coolant supply.
Select abrasive sequence, polishing cloth, load and rotation direction by material; avoid cross-step contamination.
Grind and polish step by step with cleaning in between; rotate the specimen to identify residual scratches from the previous step.
Inspect scratches, relief, pull-out and edge retention under a microscope; return to a previous step if needed.
Archive the sample ID, model/accessories, raw records, processing version and anomaly handling with cross-references. Re-measure under identical conditions or check disputed results against the reference method.
Verify the edition, specimen and configuration. Links do not constitute certification or a conformity claim.
Such devices or accessories do not necessarily produce an independent measurand. First use the workflow below to confirm the calculation object, calibration basis and input units, then use the relevant reference tools.
Reference calculations ↗Links indicate related methods or research objects, not evidence that a paper used our instruments.
Other models in Pre-grinding & polishing and the same instrument family.

LP-2

P-1

P-2

P-2A

P-2T

PG-2A
Tell us about your material, specimen and measurement goal.