SHANGHAI MICROCRE OPTICS-MECH TECH CO., LTDAbout MICROCRE400-812-7833
TOPICS

Gauge-extension and engineering strain rate

Translation pending review.

把初始标距区间实际测得的伸长速率除以初始标距,得到平均工程应变率。若输入横梁速度,只能得到受机架柔度、夹具滑移及试样形状影响的名义估计,应明确标注。

Derivation

Translation pending review.

工程应变定义为ΔL/L₀;对时间求导,L₀是常数。

Translation pending review.

把每分钟的速度除以60,换算为每秒。

Translation pending review.

压缩若以负伸长速率输入,则返回负应变率。

Common pitfalls

Translation pending review.

真实应变率使用当前长度,不能在大变形时与工程应变率混同。

Translation pending review.

局部颈缩后,全标距平均值不能代表颈缩区的局部应变率。

Assumptions

  • • 使用同一标距区实际伸长数据;恒定标距为工程应变定义的参考长度。
  • • 若用横梁速度估计,必须另行验证试验系统柔度、滑移及平行段与标距的差别。
  • • 本工具不指定任何标准试验速度,也不构成闭环应变率控制。

Illustrative example

Inputs

v=1 mm/min

L₀=50 mm

Steps

Translation pending review.

速度为1/60 mm/s。

Translation pending review.

除以50 mm得到1/3000 s⁻¹。

Translation pending review.

乘100可写为0.033333%/s。

Result

Translation pending review.

工程应变率0.000333333 s⁻¹(0.0333333%/s)。

Equation

ε̇_eng=(dΔL/dt)/L₀;v以mm/min输入时 ε̇_eng[s⁻¹]=v/(60L₀)

Symbols & units

v标距区实际伸长速率,拉伸为正mm/min
L₀初始标距mm
ε̇_eng工程应变率s⁻¹

Gauge-extension and engineering strain rate →

Related instruments & resources

Links support navigation and do not establish a model’s performance or standards compliance.

Your next research question. Let’s explore.

Tell us about your material, specimen and measurement goal.

Discuss your application ↗
Find your instrument
⌕
Search products, cases, solutions, standards and literature.